Conventional plate heat exchanger
Conventional plate heat exchanger
Plate heat exchanger consists of corrugated plates fixed with gasket and these are mounted between fixed frame and movable frame , Top and Bottom carrying bar are used for hanging the plates in between frames and the ties rods are used for tightening to the required plate pack. Fluids enter through the connections in the frame and are distributed in between plates. The fluids flow thorough alternate passages between plates by means of gasket arrangement.
EFFIECIENT HEAT TRANSFER DUE TO CORRUGATED PLATES AND THIN MATERIAL.COMBINATION OF HIGH THETA AND LOW THETA PLATES IN THE SAME PLATE HEAT EXCHANGER GIVES DESIRED PRESSURE DROP AND THERMAL PERFORMANCE WITH LESS NUMBER OF PLATES.
Optimum performance is guaranteed
Adhiam specializes in solving various heat transfer problems of our customers by associating ourselves in their design and operation team to many industries such as oil and gas, Edible oil, chemical etc
Specifications
- More than 20 sizes available with every size two to three plate pattern
- Connection size available from 20 mm to 350 mm
- Heat Transfer Area from 0.02 m2 to 1.84 m2 per plate
- Design Pressure up to 25 bar
- Plate MOC: AISI304,AISI316,SMO254, Hastelloy C 276 , Titanium , TI-Pd, Nickel etc
- Gasket MOC : NBR, NBR P, HNBR, EPDM, EPDM -P, Viton A , Viton G etc
Features and Benefits
- Efficient Heat Transfer- Reduced capital cost
- Low Weight—Lower foundation cost
- Flexibility- Easy to alter duties
- Minimised vibration-Longer life time , reliability
- Easily accessible heat transfer Area- lower maintenance
- Close Temperature Approach – Suitable for Heat Recovery and regeneration application with more recovery
Features of EcoEnergy Exchanger offered Plate Heat Exchangers
Distribution pattern in the Plate:
There is wide distribution pattern of corrugation at the entry of fluids. This helps
- the fluid distribution across the entire width of the plate.
- Avoid mal-distribution thus reducing the fouling rate.
Gasket Groove :
Deep Gasket groove ensures support to gasket from three side.
- This helps the gasket misalignment /dislocation.
Surface Finish:
The surface finish of the plates will be very smooth due the advanced pressing technology.
- This helps less resistance to fluid and hence less residence time to plate over a time period .
Single Mechanical Homogenous pressing of Plates:
We offer channel plates that are pressed in “Single mechanical homogenous Operation”.
The corrugations are wider & smoother.It will have less residual stresses and long life of plates.
Applications:
Cooling and Heating of various fluids . Fluids where the particle size is not more than 2 mm, this conventional Gasket type PHE can be used.
